Stand mount Adhesive not sticking well

[cmonster42]

I just got a new register drawer (This one) and just attached the adhesive to the bottom of our stand.It's not sticking very well though. On each spin, the stand slips a little on the surface. Any advise on a better sticking system?

Thanks! 

[Sean · Accepted solution]

@Lima @VanKalkerFarms - Thanks for the tips! 

@cmonster42 - You could also reach out directly and request a new sticker. Maybe you just got a bad one.

[Lima]

When I do install on metal mount I use   http://amzn.to/2j5vczB
(Stick it to do existing tape, press for couple hours.)

I prefer drilling the drawer box   (bigger hole on bottom and smaller on top, bigger for screwdriver to pass)
and securing It with screw. ( I get screw from homedepot and cut it so it clears drawer)

[VanKalkerFarms]

I don't know what to tell you but one of our setups is exactly this, with the sticky adhesive from the square stand directly to the vesario cash drawer and you can pick up the stand and the drawer will come off the counter.  all the rest are bolted directly to the counter.  3M makes spray cans of adhesive that you could try.

[Sean · Accepted solution]

@Lima @VanKalkerFarms - Thanks for the tips! 

@cmonster42 - You could also reach out directly and request a new sticker. Maybe you just got a bad one.

[greenecanteen]

Hi, we need a new adhesive disk for our square stand and I can't seem to track one down. Does anyone have any suggestions? I called Square and they said they don't stock them anymore. 😞

[ashc]

Hey @greenecanteen! Welcome to the Community!

We should still have replacement adhesive mounts that we can provide for free.

Can you send me a DM so I can get some shipping information from you and I can get someone on our Customer Success team to send one out if it is available? 

[greenecanteen]

@ashc Thank you! My shipping address is [personal information redacted]

Thanks!

-The Greene Canteen

[ashc]

No problem @greenecanteen!

I'm placing the order now and I also redacted your personal information from your post since this is a public forum for your privacy purposes.

You should be receiving a confirmation email for the order shortly! 🙂

[greenecanteen]

Thanks! I tried to DM you but the site kept giving me an error. 

[ashc]

@greenecanteen No worries! I placed the order as well so you should be seeing the confirmation email now. 

[Lev2sthyacinthe]

Hi I’m in the same situation I need a new adhesive mount! Could you let me know how to proceed. Thanks!

[Arie]

Hey @Lev2sthyacinthe,

Thanks for writing in & welcome to our community 🙂 👋
 

You can reach out directly to our team and request a new sticker. 

[cmonster42 · Accepted solution]

Thanks everyone for the tips. I figured out that the problem is not the adhesive. It was that when I screwed that plate onto my stand, I did it to finger tight, since that was as far as I could go. When I stuck it down, the adhesive was working so well that it didn't need that much tork to unscrew slightly and thus feel like it was going past the stop on the stand. So I just turned the whole stand so it tightened down on the plate itself and got it real tight, thanks to the strength of the adhesive. It's now fine.

[pelicanspoq]

We need replacement adhesive for our stand as we are moving it.  How do we get that?  

[katieand]

Hi @pelicanspoq - Check out @Sean's best answer from above! You can give our team a call to get a new sticker!