Is this printer compatible with Square Stand? Epson TM-T88V, M244A ,Serial# MXDF709359

The title of this thread has been edited from the original: Epson TM-T88V, M244A ,Serial# MXDF709359

 

Hi, Everyone

Does anybody know if this printer compatible with Square Stand?

Epson TM-T88V, Model M244A, Serial# MXDF709359

Thank you very much in advance!

 

8,152 Views
Message 1 of 7
Report
6 REPLIES 6
Admin

Hi @Robby! According to our hardware compatibility chart, the Epson TM-T88V is compatible with the Square Stand!

nika
Community Program Manager, Square
8,099 Views
Message 2 of 7
Report

@nika Thank you for the response. As I know Epson TM-T88V has different models and mine is M244A. I tried to connect my printer with Square Stand with usb cable but it showed not supported. Would you please tell me what’s the right way to connect my M244A printer to Square Stand because maybe I connected it wrong? 

Again, thank you very much!

8,097 Views
Message 3 of 7
Report
Admin

@Robby You're probably doing everything right as far as connecting goes! There are some models that are considered "untested" with our Square stand. It very easily could be that the model you're using is not compatible. Make sure that you're going through these set up steps. If these are the steps that you've been following to connect your printer and it's still saying that it isn't compatible, then unfortunately you might want to look into trying a different printer.

nika
Community Program Manager, Square
8,049 Views
Message 4 of 7
Report

I have an Epson M-133A receipt printer, Is it compatible with the square stand??

Tags (1)
7,993 Views
Message 5 of 7
Report
Square Community Moderator

Hi @printworkz2018! Welcome to the Community.

 

I moved your post to an existing thread that has a hardware compatibility page included in it to reference.

 

Check out @nika's post above for that link to check if that printer is compatible. 

Ashley C
Community Moderator, Square
Sign in and click Mark as Best Answer if my reply answers your question.
7,945 Views
Message 6 of 7
Report

You must program the print to be in printer mode not vender mode

hold feed button while turning on your printer

then press the feed button 11 times then hold the feed button down

then press the feed button 3 time then hold the feed button down

then press the feed 1 time then hold the feed button down.  Then press the feed button 2 times then hold it down it should then be in printer mode and work with the square stand 

7,816 Views
Message 7 of 7
Report